Fan Mount for CTC & Makerbot Replicator Clones

cults3d

There is no cooling fan on the CTC by default, which is problematic for PLA... I had a big power supply fan so I just build this one You can put on the front, the left and the right this fan mount You just need 4 Screws + Bolts to mount it 2 of them are for adjusting the height On the photos, I have some duck tape in order to test different cases. On the benchmark, there is a bed levelling issue and I switch on the fan from the start (so warping...) The result is not terrific but it will improve. Bridges that are behind the fan are even much better. Second test, I put the fan on the left and the bed was levelled. The distance is a bit longer, it helps to distribute a bit more the air, little improvement on the result A second fan is needed in the right side too