Fan Duct and Wire Guide/Cover with switch to permanently mount laser on Overlord Pro

thingiverse

Updated 2/21/2016 - I am backing away from this, the cooling was too weak and the weight with the laser mounted was just too great for the printer. To get good prints, I had to slow it down way too much. The laser is no longer permanently mounted - please consider this before trying this project out. This modification is based on others at thingiverse.com and tinkercad.com. It's designed specifically for the Overlord Pro to allow permanent mounting of the laser module while still using the fan for cooling the print. A 2-pole/3-position switch has been added between the main board connector and the fan/laser, making it easier to route cables and providing an anchor point with a wire tie. Please scale the cover to about 105% as it was just a bit too tight for my printer. Printing Settings: Printer: Overlord Pro Rafts: No Supports: No Resolution: .8 layer Infill: 50