Fan bracket for the Mosfet

myminifactory

Installing the Mosfet on the Anet A8's Hotbed revealed a critical issue: the sensor wires were touching the heat sink, which was not acceptable. The solution was straightforward - I needed a bracket for the 40mm fan that would prevent the Mosfet's heat sink from damaging the wires and also cool it down simultaneously. This was a perfect setup. To achieve this, I clipped the bracket onto the Mosfet board itself, eliminating the need for screws. Next, I simply snapped the 40mm fan into place on the bracket, making sure the label faced outward to indicate that it pulled air out of the heat sink rather than blowing into it. With that done, I connected the fan's wires to the Mosfet's DC voltage connections, and my problem was solved. Additionally, I downloaded a double mosfet holder from https://www.thingiverse.com/thing:2018906 to ensure a secure fit. Update 1: A new design has been added that is taller to accommodate Mosfets with large heat sinks.