Fan and Bl Touch Front Mount (Anet A6)

thingiverse

BlTouch Mount Including Offset for OEM 40 mm Fan. More mods are yet to come, but here's what I've got so far. ***June 19th: New Version Uploaded*** I just uploaded a new version of the BlTouch mount, including an offset for the OEM 40 mm fan. It also includes a front fan and part cooler fan mount in one, making it a three-in-one mount. I haven't tested it yet, so your mileage may vary. ***June 22nd, 2018*** I've successfully printed the Fan_Mounts_and_bltouch_mount.STL with some minor adjustments. To get the radial fan to fit properly, you'll need to add some spacers between it and the mount. The Z-offset I used was -2.75, while x and y were approximately 31 mm and 20 mm. ***July 2nd, 2018*** I've uploaded a final version of the BlTouch mount, which includes an offset for the OEM 40 mm fan. With this new version, you'll need less support during printing, especially when using the fan mount on the bed. I used auto in Slic3r without any issues. My Z-offset was approximately -1.3, while x and y were the same as before. ***December 14th*** I've added a mount for magnets to this design. To use it, print eight caps and attach four mm round, two mm high magnets to each cap. Then, glue them into place in the corners of the fan. This will give you a secure hold even at heights up to eight mm. ***January 17th*** I've added the Volcano mount to this design. It's a magnet-only mount that allows for easy access to your extruder gear tooth while still mounting fans and BlTouch on one print.