Fan Adapter for Mosquito Hotend - 25mm to 40mm

thingiverse

This was based around the Mosquito mount by phelanp11 found here - https://www.thingiverse.com/thing:3534197 and works with both phelanp11's mount and brotherchris's remix. I loved the simplicity of the design of the mount, both the original and Chris's remix, however I didn't want to reuse the stock Ender fan shroud and cooling fans as they're loud and can be improved on as far as performance goes. That said, I also didn't want to stick with the stock Mosquito 25mm fan as it's even louder than the Ender stock setup, so I was at somewhat of an impasse. Being unable to find a suitable solution for a fan mount adapter, I decided to create my own. ======================================================== This is technically version 1.2 of the shroud, however it's the first released version. The fan is only set up in one orientation, and it will fit snugly between the original 5015 blower duct (usable by Chris's remix and the original), and the BLTouch mount on the original. The fan is also mounted just high enough to have good visual clearance of the nozzle. The holes for the 40mm fan are designed to fit M3 bolts, and the Mosquito holes are designed to fit the proper screws for the mount. Make sure you don't snug down too tightly as there's a slim amount of support material under the Mosquito mount holes. ** For best print results, print at 100% infill with supports, and leave the part orientation with the 25mm side touching the print bed ** Please let me know if you run into any issues with this mount, as I based it on my own printer which may vary slightly from the rest.