Fallout Wasteland Warfare - Box Insert

thingiverse

This is a work-in-progress design for a box insert in Fallout Wasteland Warfare. The primary goal is to create an easy-to-use setup system that can accommodate all components from the box while also allowing for additional miniatures to be added. Since the bases of the miniatures are decorated and may be prone to damage, I've opted against implementing a locking mechanism that requires the miniatures to stand upright. This reduces the risk of damaging the painting on the bases. To achieve this goal, I propose the following: * A single box for units and AI cards (sleeved) should provide ample space for all cards. * Another box is dedicated to mini EU cards (sleeved), which should be sufficient for starter sets or a few boxes of sleeved cards. If you don't sleeve your cards, this box can also accommodate the settlement expansion. * A third box will hold the deathclaw miniature with its 50mm base, standing upright as intended despite initial reservations about potential damage. * Four additional boxes will store miniatures with various base sizes: 16 x 30mm bases, 9 x 40mm bases, and two groups of smaller miniatures (dogs) and a tall Preston Harvey figure from the Survivors Core box. * Six more boxes will hold mutant dog miniatures with 40mm bases. * Four token boxes with lids are included to prevent tokens from escaping during play. These boxes feature channels for easy rubber band attachment, ensuring that tokens remain contained. To protect your painted miniatures and prevent damage, consider adding felt or fabric to the holders and possibly some foam on top of the deathclaw box to keep it stable. Note: This design will barely fit within the original box dimensions. Adding the rules and playmat may cause the lid to be raised by approximately 1 cm (0.4 inches).