Face shield COVID 19 FINAL

thingiverse

This is the final version of a modification that has been extensively refined. Its hundred times better than the original PRUSA design, with holes created using a 3-hole punch readily available everywhere. In contrast, the PRUSA design requires a very specific pattern of holes that may not be feasible for everyone. The PRUSA design also happens to be complex and time-consuming to print, whereas this revised design is simple and prints quickly. It's even easier to clean, install screens on, remove, and put on your head without needing straps. If desired, a rubber band can serve as an alternative strap. This design surpasses the original in numerous ways. I do not intend to sell printers or filament or printed parts of this shield like PRUSA does. PRUSA's sales skyrocketed after their shield promotion was picked up by media outlets. I have no intention of criticizing PRUSA, whose hardware and software are excellent, and who have made significant contributions to the open-source community. However, I strongly disagree with their "do it our way only" approach, which discourages others from expressing dissatisfaction or suggesting alternative solutions. Just because I can express my views does not mean they will be widely accepted; PRUSA has effectively told everyone to ignore other designs and adopt theirs exclusively.