Face mask hanger - no stress/pain on ears

thingiverse

Due to the COVID-19 outbreak, people are constantly wearing face masks that cause stress and pain in their faces, particularly on their ears. The elastic bands holding the mask in place can be uncomfortable, especially when they dig into the skin around the nose, mouth, and chin. Adjusting these elastic bands is not recommended, which is why I designed this innovative hanger with a hook at the back of the head/neck and a Y-shaped band that distributes the force evenly to prevent pain on the ears. The sizes of this hanger can be adjusted by using different knots provided or following the suggested recommendations. Here are all possible sizes: To adjust the size of the hanger, it's recommended to use software like Cura or similar tools. * Size XL: 8.26 inches x 2.95 inches (0.016 inch thick) * Size L: 7.87 inches x 2.76 inches (0.016 inch thick) * Size M: 7.09 inches x 2.56 inches (0.016 inch thick) * Size S: 6.69 inches x 2.36 inches (0.016 inch thick) To print this hanger, no support or brim is required due to its design. Printing time is approximately 30 minutes. When using the hanger, make sure it can be washed with a disinfectant solution (1:99) or sprayed after use. To wear your face mask comfortably, fix one side of the band into suitable knots on the hanger first. With one hand holding the face mask and the other hand holding the hanger, put the hanger and mask onto your mouth and nose. Then, secure the other side of the band by fixing it into the knots at the back of the hanger. Adjust your mask to the center and press the wire against your nose before pulling the mask down to cover your chin.