Face mask fitter

thingiverse

3D print mask fitter (PLA only) The masks that we wear protect against germs only about 38.5% from the research results referenced below. More than 70% of the protection required a 3D-printed mask-fit mask, with the model being scanned with a face-scanning iPhone model. But not everyone has access to the face scanning system. So I tried and designed a new mask to make it accessible to everyone. It's a design for everyone. New must be designed specifically. There are sizes s m l xl By allowing the mask to adjust to its own face shape from hot forming, just by soaking in hot water. can bend the mask to fit your face Curved design to match the shape of the face and chin, nose. Design of fasteners to hold both normal rubber bands. Round or flat mounting rubber Tried it and it works fine. How to use All you have to do is dip it in hot water for about 2 minutes and bring it up quickly. Place it on your masked face. There will be a little residual heat here if you If you are not sure, please wear a double mask. If it doesn't fit your face, use a hair dryer to blow between the center creases and squeeze them together. If you distribute them to remote areas and there is not enough water, you can shape them with warm sand that sits in the sun. or engine exhaust But be careful And don't let the children do it alone+!. And you can recycle the rope from the old mask and use it if you really need it. If you want another design for suitability, please inquire me by email.