Face avant et arrière renforcées DiscoEasy 200

thingiverse

**Enhanced Front and Back Faces** **A Version with or without Pause Button** The version with a pause button is intended for those who already have a pause button on their machine. Two versions of the front face, with or without a pause button, are reinforced by a 10X4 mm steel bar in the upper part and a 10X2 mm steel bar in the lower part. These bars are sold at hardware stores and are therefore easily obtainable. This is done without ruining the overall appearance of the machine, as they take up less space than the 8mm round bars used in other publications; This modification involves replacing all original adhesive domes with domes with a diameter of 13 MM and a thickness of 4.5 mm, such as those distributed by Standers under reference PG-13X-20PS2 (hardware store) **Note:** The adhesive domes on the front face will be glued directly onto the visible 10X2 mm steel bar at the bottom of their housing. The plugs will close the openings in the sides of the front and back faces. **Material:** - 1 micro switch without lever and with a cable of at least 120 mm length - 2 steel bars 10mm x 4mm x 160 mm (hardware store) - 2 steel bars 10 mm x 2 mm x 150 mm (hardware store) - 8 adhesive domes 13 mm (hardware store) **Revision:** - 08/10/2018 Addition of double extruder rear face