FABtotum Bulldog Lite mount

thingiverse

With a path directly to the hot end and nozzle established, a fan model is incorporated; however, acquiring one separately remains necessary. The PCB has yet to be manufactured for connection to FAB. This model may require modifications and has not been thoroughly tested. It has undergone testing to verify its size but operates nonfunctionally at present. EDIT: A repair was applied to the PCB cover securing it atop the mount's top section, with additional fixing holes and locking mechanisms introduced, along with a hole at the rear for extruder wiring. EDIT: The air path to the nozzle has been altered to accommodate various 5-volt blowers, along with mounts and pins permitting fixation of this path to the lower section – it is advised to employ epoxy in this connection. Additionally, snap-together assembly capabilities have been included while maintaining screw holes for possible utilization. EDIT: A fitting assessment indicates that this configuration will cause an interference with a rear case (in instances where it's installed), and, critically, the hot end protrudes insufficiently; therefore, this setup currently is unsuitable for use.