FabScanPi / RaspiCam adjustable Camera Mounting

thingiverse

This is an adjustable camera holder for the 3D Scanner FabScanPi (Model 2016 and later). The standard camera used is the RaspberryPi Cam V1.x or V2.x. You can adjust the x-axis and y-axis to a range of +/- 1 cm, and you can correct the angle by tightening three mounting screws at the rear. Optionally, you can print "Sled I LED" for use with the "RPi-RingLicht" Board. Post-Printing Bill of Materials To build the camera holder, you'll need the following parts: To be printed: 1 x Sled I (Camera) or 1x Sled 1 LED (with LED Board) 1 x Sled II (Frame) 1 x Sled III (Rear Panel) Additional Parts (Vitamins): 2 x Screw M3 x 40mm 5 x Nut M3 4 x Brass Shaft, Length: 53mm 4 x Pressure Spring (from a Ball Pen / Biro) 4 x Screw M 2.5 x 6mm