FabScan CUBE Turntable

thingiverse

I've designed a full-fledged turntable holder that screws directly onto a stepper motor shaft using an M5 nut and screw for extra stability. My idea was sparked by the Stepper Shaft Thumbwheel, but I rebuilt this design from scratch using Autodesk Fusion 360, adding some innovative tweaks along the way. To give it a clearer look, I added slim cross lines on top to indicate its center. To bring it to life, I printed it upside down on the bed, with layer height set to 0.2mm and infill density at 25%, finishing it off with four layers of beige PLA - two on top and bottom, and another two for outer coverage. Since there were areas with complex overhangs, I also manually added support where needed in the horizontal holes.