Fabrikator mini stand with built in vended fan

thingiverse

This is a Fabrikator mini V1.5 3D printer stand with a built-in vented fan, specifically designed for secure fitment. The stand's excellent design ensures it won't fall off when lifting the 3D printer. Additionally, it features a built-in cooling system for efficient heat management on the printing board. Two versions are available: a 25x25mm or 30x30mm fan (available on Ebay). To set up your printer, you'll need to create two stand sets - one for the front and one for the back. The larger 30x30mm stand was added on February 25, 2016. Print Settings: Printer: Fabrikator mini V1.5 Rafts: No Supports: Yes Resolution: 0.2mm Infill: 15% Notes: I use Repetier Host with Cura Slicer for all my prints. With PLA Filament, I set Support Type to "everywhere" and Quality to "0.2mm". Printing the stand on a Fabrikator mini V1.5 takes approximately 9.5 hours. When assembling two pieces together, place them on the printer before gluing, ensuring they remain aligned. Be cautious not to get glue on the printer, as this can make it difficult to remove the stand if needed. When installing the fan, you can route wires through the vent for a clean and organized setup.