Fabrikator Mini counterbore parts

thingiverse

These two parts will help you extend the travel on both the x and y axis of your Fabrikator Mini by TinyBoy.\nYou can significantly increase the x-axis travel by simply installing the counter-bored x-axis idler washer. I've achieved an impressive extension of up to 90mm, allowing for even more versatility in my projects. However, keep in mind that you'll need to swap out your print bed if it's not at least 90mm wide.\nThe gantry part takes care of the hot end colliding with screw heads at the minimum y-axis travel point. Although I've experienced issues with other screw heads in my setup, many users have successfully avoided collisions just by adding this one part.\nKeep in mind that results may vary depending on your specific printer configuration.\nPrint Settings\nPrinter: Fabrikator Mini Rafts: Doesn't Matter Supports: Doesn't Matter Resolution: Any Infill: 100% for maximum strength