Fabrikator Closed Chamber upgrade

pinshape

Upgrade fabrikator to a closed chamber, ensuring a constant temperature for printing, which is crucial for ABS and Polycarbonate but less so for PLA. Reducing noise was also an essential goal, which has been successfully achieved. However, it's still possible to access the top compartment easily. To create this upgrade, you'll need to drill holes into the sides yourself and trace them out. The required materials are: * Plexiglass 4mm: + Left part: 20 x 24 cm + Right Part: 20 x 24 cm (Do not insert a screw in the top right corner, as it will block the stepper motor) * Top: + 24.5 x 5 cm (Two pieces) + 21 x 5 cm (Two pieces) + 24.3 x 21.8 cm (Drill a 6mm hole in the center) * Front door: + 26 x 22.5 cm + 26 x 4 cm For assembly, use the following parts: * 7x M3 nylon bolts and screws for the sides * 16x 2.9mm x 9.5 mm metal screws Print the following components: 1. Door lock 2. Two charnière pieces 3. Four coin pieces 4. Four supportcote pieces 5. Two Support_90_long pieces 6. Two Support_90_court pieces Refer to the pictures for assembly instructions. For PLA printing, keep the internal temperature around 31°C, with a first layer at 63°C and other layers at 40°C. Leave the door open about 2cm.