Faberge Egg

thingiverse

Egg pieces should fit together perfectly, but a thin band about 0.25 inches wide will be visible running through the middle of each piece. The finished product won't resemble the seamless design shown here because that's not how it was created. I'll try to update the entire design before Easter with internal clips so you can store candy inside. Note that this design hasn't been printed yet, and results may vary. It's a simple Fabergé egg in two halves with a stand. You could use it to hold jewelry or fill it with candy for Easter. Print Settings: - Printer Brand: MakerBot - Printer: MakerBot Replicator (5th Generation) - Rafts: Yes - Supports: No - Resolution: 0.2 mm - Infill: Any Notes: This design hasn't been printed yet, so let me know how it turns out. How I Designed This: I created this in Blender 2.78.