F450 TBS Discovery Carbon Tube Tuning Kit

thingiverse

Edit:\nI crafted five angular versions of the 37mm Connector. Seven, ten, twelve, seventeen, twenty degrees to achieve that spidey look and minimize prop obstruction in your field of view!\nI sought to extend my frame's arms, which led me to conceive putting some 16mm tubes on it.\nThis entails thirteen-inch props for 250mm long tubes ;)\nI share this result with the community ;).\nThe Connector comes in three distinct heights.\nYou will need\n50-45mm M3 screws for the 37mm height (original height)\n40-45mm M3 screws for the 32mm height\n35mm M3 screws for the 24mm height \nand two short ones for the back screws\nThe rail holder is designed for 10mm carbon tubes with a sixty-millimeter axis-to-axis span.\nThe two holes to the side fit snugly into the long slots on the bottom plate\nYou can use this setup to mount a $50 two-axis gimbal to the rail (center hole utilized)\nThe Lipo holder is necessary if you want to place your lipo as a counterbalance at the back (gimbal in front)\nThe Antennaholder is designed for the FrSky X8r antenna mounthttp://www.thingiverse.com/thing:411491\nThe clamps are for different wide carbon motor mounts. Simply print four each\nI employed the landing gear found here:http://www.foxtechfpv.com/tarot-small-size-electric-retractable-landing-gear1-side-p-1811tarot-small-size-electric-retractable-landing-gear1-side-p-1811.html\nEDIT:\nI have added a 37mm thick version to replace the arms with original height connectors. This enables you to use it on your TBS Discovery ;).\nAdditionally, I included a slotted version of the 37 and 32mm versions to accommodate some wires (LEDs perhaps anyone??)\nPrint Settings\nPrinter Brand: \n MakerBot\n \n Printer: \n MakerBot Replicator 1\n \n Supports: \n No\n \n Resolution: \n 0.2\n \n Infill: \n 40-70%\n \n Notes: \n Print four connectors, install some screws through the holes, and then fly ;).\nI recommend printing it in ABS or using Colorfabb XT like I did.