F450 Drone Electronics Housing
thingiverse
This is a complete Electronics Housing for the F450 Type Quadcopter found here: https://www.thingiverse.com/thing:1206960 In this case, you can store PDB and Flight Controller with 30.5mm spacing like Pixhawk Mini or any standard INAV capable F3, F4, or F7 flight controller. It also has enough room to put a 30.5mm receiver module on the same stack. The cover part includes mounts for a 3DR radio and an Eachine TX526 video transmitter. The telemetry module can be mounted with a small cable tie, and the video transmitter will hold itself with the plug or can be additionally glued in place. The VTx channel display and control button are accessible from the top. The GPS mount is hollow to hide cables inside. The VTx needs an extension cable to mount the antenna on the side of the housing. Attention: When using a flight controller with integrated magnetometer, do not put the PDB inside the housing because it will distort the compass. However, when using a GPS with magnetometer, this is no problem. The cover is screwed down with 2 short M3 screws and also the GPS mount is screwed onto the cover with M3 screws. Simply screw down the base with one screw from each leg. The small 2mm holes on each side of the cover are preparation for 2.4GHz receiver antenna cables. Any suggestions? Just leave a comment below. Links for fitting electronics: * 3DR Telemetry (433MHz): https://www.banggood.com/3DR-Radio-Telemetry-433MHZ-Module-For-APM-APM2-Europe-p-85233.html * 3DR Telemetry (915MHz): https://www.banggood.com/3DR-Radio-Telemetry-915MHZ-Module-For-APM-APM2-p-73539.html * VTx: https://www.banggood.com/Eachine-TX526-5_8G-40CH-25MW200MW600MW-Switchable-AV-Wireless-FPV-Transmitter-RP-SMA-Female-p-1083642.html * VTx Extension Cable: https://www.banggood.com/GEPRC-100mm-Low-Loss-Antenna-Extension-Cord-Wire-Fixed-Base-for-FPV-Multicopters-SMARP-SMA-p-1181450.html * VTx Antenna: https://www.banggood.com/Realacc-Pagoda-Antenna-RHCP-Right-Angle-5_8G-5dBi-50W-Omnidirectional-Omni-FPV-Antenna-SMARP-SMA-p-1219943.html * Receiver: https://www.banggood.com/Flysky-X6B-2_4G-6CH-i-BUS-PPM-PWM-Receiver-for-AFHDS-i6s-i6-i6x-Transmitter-p-1101513.html * GPS (with MAG): https://www.banggood.com/Ublox-NEO-M8N-Flight-Controller-GPS-with-Protective-Shell-for-PIX-PX4-Pixhawk-p-1005394.html
With this file you will be able to print F450 Drone Electronics Housing with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on F450 Drone Electronics Housing.