f105vZz qudcopter

thingiverse

This is the frame design for a home quad, measuring 105mm diagonal. For this project, you can use various components from the Hubsan X4 board and FPV equipment. I've opted to use the following parts: Eight 20mm motors sourced from the Hubsan X4 D drone. A CC3D Mini flight controller. Custom-made soldered ESCs for brushed motors. A DIY FrSky 8CH receiver module that operates in PPM mode. The Boscam FPV transmitter, a model TX5813, provides wireless video transmission on the 5.8G frequency at a power of 10mW. A 600TVL CMOS camera with a 1/4 inch lens and an angle of 170 degrees is used for capturing footage. The quadcopter will be powered by 250-500mah LiPo batteries and 100mah LiPo batteries dedicated to the FPV system. Print Settings: Rafts are not necessary, as the frame supports them regardless. Infill settings: 100% density.