F1 Mclaren MP4-30 Steering Wheel Support

prusaprinters

<p>F1 Mclaren MP4-30 Steering Wheel Support.</p> <h3>Print instructions</h3><h3>Category: Vehicles Summary</h3> <p>F1 Mclaren MP4-30 Steering Wheel Support.</p> <h3> Print Settings</h3> <p><strong>Printer Brand:</strong> Ultimaker</p> <p><strong>Printer:</strong> Ultimaker 2</p> <p><strong>Rafts:</strong> No</p> <p><strong>Supports:</strong> Yes</p> <p><strong>Resolution:</strong> 0.2</p> <p><strong>Infill:</strong> 15%</p> <p><strong>Filament:</strong> Fillamentum PLA Fillamentum Rapunzel Silver, Vertigo grey and Ruby Red.<br/> <strong>Notes:</strong></p> <p>General print settings.</p> <p>Nozzle: 0.4 mm<br/> Layer Height: 0.2 mm<br/> Line Width: 0.35 mm</p> <p>Wall Line Count: 3<br/> Activate “Outer Before Inner Walls”<br/> Initial Layer Horizontal Expansion: -0.1</p> <p>Infill Density: 15%</p> <p>Infill Speed: 60 mm/s<br/> Outer Wall Speed: 25mm/s<br/> Inner Wall Speed: 35 mm/s<br/> Top/Botton Speed: 25 mm/s</p> <p>Support: Yes<br/> Support Over Hang Angle: 70<br/> Support Density: 15%<br/> Support Interface Thickness: 0.6 mm</p> <p>1xBase_SW<br/> Post Procesing / Pause at layer (change colour): 39, 42 (Layer Height: 0.2 mm).</p> <p>Recommended filament: Fillamentum Rapunzel silver, Vertigo Grey and Ruby Red.</p>