F-F-Fiddle Grover Remix

thingiverse

First, I'm still learning about 3D printing, Fiddles, and 3D modeling in general. This remix of the Bout for the F-F-Fiddle by OpenFabPDX is designed to work with Grover Ukulele Tuners, specifically 9NB Sta-Tite Ukulele Tuners, Nickel with Black Buttons, which can be found on Amazon right now for $13.99, significantly reducing the overall cost of the fiddle. Since these tuners are shorter than the originals, I had to narrow down the body at this point, and printing at 30% infill cubic worked out fine without any issues so far. As a newcomer to modeling, my topology isn't as polished as the original in this section, but sanding it down makes it almost unnoticeable for the most part. All the wiring tubes are intact and functioning properly, although I did need to increase the angle of some of the bends, which made it slightly harder to push the wiring through. This is my first posted Thing, so please feel free to give me feedback on what I did right or wrong - whatever's helpful!