EZT3D T1 Supports

thingiverse

Adjusted the file to fit my EZT3D T1 printer, adding stability with a stiffer base.\r\nSome minor filing may be needed on the left front support to accommodate the edge of the power cable insert.\r\n\r\nSpecial thanks go out to these talented designers:\r\n\r\n namomo https://www.thingiverse.com/thing:2047527\r\n\r\n elmuchacho https://www.thingiverse.com/thing:626279\r\n\r\nI drilled through the side of the supports, adding a long screw for extra security.\r\nThis hole was not included in the original design.\r\nA future design update I'm considering is to straighten the back edge, allowing for an additional screw higher up, as power cables run up the front, making the front screws unusable from their original position.