EZDmag 25 dart drum style nerf magazine

prusaprinters

This is a EZ load remix of Thanhlon nerf drum. It uses 2 drum springs, A few blaster screws, and a foot or so of fine string /fishing line.Tie string to bottom of follower and run it through the small hole in the barrel. Assemble the mag and springs then pull the string and tie a knot that will fit into the large hole in the barrel. You will want the string short enough that it keeps a little tension on the springs to prevent the follower from being shot out of the top if you let go under tension with no darts in mag.You will also need to sand the inside of the mag, I went to 400grit and sanded VERY smooth.Loads 25 darts no problem.If you use full auto you want NEW DARTS and SAND, SAND, And then SAND SOME MORE.NOT ORIENTED FOR PRINTING