EZABL Single fan Gen2 Ender 5 mod V2

thingiverse

I'm trying to get this setup working with a Single fan Duct. The base of the original EZABL mount was wider than I needed, so I extended it a bit to the left. It's not the prettiest solution, but it works and keeps the EZABL level. Plus, it avoids a potential problem with the belt lock. To install it properly, you'll need to remove the support nuts from the EZABL and place them on top of the mount instead. If you try to pre-thread the nut and set it down, the belt might hit it. I've set my X Offset to around -2 or 4 degrees, but I've chosen to use -48 for myself and so far, it's working fine. The Y offset is still at -12 since I didn't move it back or forward.