EzABL Mount for stock Ender 3 (Pro) carriage and eB Shroud

thingiverse

This is a remix of tito114's excellent TH3D EzABL mount (https://www.thingiverse.com/thing:3012926). I recently purchased an EzABL Pro and was looking for a strong, yet compact mount. I liked tito114's design, but the amount of offset to the left meant the X-carriage couldn't move far enough to the right on an Ender 3 Pro in order to center the probe grid onto the build plate. And since I am using the eB shroud by gibbed (https://www.thingiverse.com/thing:3419531) instead of a fang-type cooler, I have extra room to place the EzABL closer to the hotend. I also enlarged the top hole to slip over the wheel pan head screw, so no need to remove the wheel. The fit is just a smidge larger to allow for a tiny bit of play to align the mount perfectly vertical. As the original, you'll need a single, short M3 screw to mount it. I measured the offsets to the stock hot end as follows: X = -44 mm Y= -19 mm I did also update my firmware to set the max X distance to 245mm instead of 235mm (the bed size) and now a 3x3 probe grid is pretty close to centered perfectly on the X-axis.