EZABL Mini mount for Titan Aero

thingiverse

This is a custom mount for the TH3D EZABL Mini that fits over the Titan Aero hot end fan. I created it because I prefer modularity and didn't want to disassemble my existing mount just to add an EZABL sensor. This design should also work with sensors that are 12mm in diameter. If you need a larger one, let me know in the comments, and I can easily modify my design for a different size. You can print this as is, with no supports. I recommend printing it with 20% infill, three walls, and PLA filament. Important note: The mount blocks the fan slightly, but it still moves plenty of air. I did notice a tiny bit more noise (at a higher pitch). It doesn't bother me, but is noticeable. I might experiment with different designs later, but I'm content with this one for now. To install this mount, remove the two horizontal self-tapping screws from the Titan Aero fan. Then, find slightly longer M3 screws - 14mm length should work. If not, add a washer and screw them in. Do not over tighten. You also need to set your probe offset. If using the TH3D unified firmware, ensure that CUSTOM_PROBE is selected. Make the necessary changes according to my settings below. These settings depend on the Titan Aero mount you are using and may be different. #define X_PROBE_OFFSET_FROM_EXTRUDER 48 #define Y_PROBE_OFFSET_FROM_EXTRUDER -8 If you want to use the same setup as me, here is the mount I'm using: https://www.thingiverse.com/thing:2460377 I am using this part cooling fan: https://www.thingiverse.com/thing:3123957