EZ - Wallet

thingiverse

**A wallet:** ============== - easy to print - easy to use - easy to carry Take care of your cards and documents so that they do not bend. Quick access to all your cards. Hold coins and money. Fits easily in a pocket *A full print takes around 6 hours Damaged parts are easily replaceable (CardHolder, LockPin, Hinges) **Can print it in to sizes:** - Slim for standard credit card size Internal size 60.4 x 95.6 mm external size 76.0 x 110.0 mm - Normal for wider cards and documents. Internal size 67.6 x 95.6 mm external size 83.2 x 110.0 mm **Versions:** - Fully 3D printable version --- with a lock pin to secure the wallet. The files that you have to print are: 1 x Body.stl/BodySlim.stl PLA 1 x LockPin.stl PLA 1 x CardHolder.stl TPU/Flex 3 x Hinge.stl PLA Additional parts A piece of flex filament (400 mm) A piece of PLA filament (10 mm) - Magnets version --- with magnets insert to secure the wallet. The files that you have to print are: 1 x BodyMagnets.stl/BodyMagnetsSlim.stl PLA 1 x CardHolder.stl TPU/Flex 3 x Hinge.stl PLA Additional parts A piece of flex filament (400 mm) 2 x neodymium rectangular magnets (4x4x2 mm) *Make sure to add a pause command in the GCODE to insert the magnets (M600 or M601) at 9.8 height or pause manually the printer. **Assembly instructions** - Take the body part with the deepest rail and insert a piece of flex filament around the part. - Put together the body parts and insert the hinges with some pressure (press in a flat surface like a table). - Take the cardholder printed in flex material and insert gently into rails all the way inside the wallet. - It is done!! *For fully printable version:* - Take the lock pin, insert in the body side with the little hole for the lock pin and put a piece of PLA filament to secure them. Print Instructions =================== **Body files** print with **non flexible material like PLA** layer height: 0.2 ( For better finish results use variable layer height at 9.4 mm with a layer resolution of 0.1 ) No supports required Perimeters: 3 Minimun shell thickness: Top/Bottom 1 mm Detect thin walls: activated Fill density: 15% Fill patern: Gyroid *For bodyMagnets files add a pause (M600 or M601) at 9.8mm height to put the magnets **Hinge** print with **non flexible material like PLA** layer height: 0.2 No supports required Perimeters: 3 Minimun shell thickness: Top/Bottom 1 mm Detect thin walls: activated Fill density: 15% **LockPin** print with **non flexible material like PLA** layer height: 0.2 No supports required Perimeters: 3 Minimun shell thickness: Top/Bottom 1 mm Detect thin walls: activated Fill density: 15% **CardHolder** print with **flexible material like TPU** This is a kind of challenging print but not to much, so **slow down** because of the thin walls and flexible material. *If your print have holes in the sides because the material dont stick together don't worry it works as well layer height: 0.2 No supports required Perimeters: 1 Minimun shell thickness: Top/Bottom 1 mm **Detect thin walls: activated** Fill density: 95% Fill Patern: Rectilinear **Extrusion multiplier: Increase a little (+ 0.02)**