Eyepiece Raspberry pi Camera adapter for 33mm eyepiece Stereo microscope (like Wild M8)

thingiverse

Inglish: This is an adapter for the raspberry pi camera (rev 1.3; you can get it for 3-4 USD on Aliexpress) and is used to put it on the eyepieces of any stereo microscope with 32-33mm diameter. It has spaces so as not to press on the microcomponents that the circuit has and 2 holes for M3 screws, to be fixed with more force to the eyepiece if necessary (in my case it was very well attached without these). There are 2 lengths in case the focal length of your microscope is different. There is also an internal margin that limits the glass of the eyepiece from touching the camera and scratching it. Español: Este es un adaptador para la cámara de raspberry pi (rev 1.3; que se puede conseguir por 3-4 USD en Aliexpress) y sirve para ponerla sobre los oculares de cualquier estereo microscopio con 32-33mm de diametro. Tiene espacios para no presionar sobre los microcomponentes que tiene el circuito y 2 agujeros para tornillos M3, para ser fijados con más fuerza al ocular si fuere necesario (en mi caso quedó muy bien sujeto sin estos). Hay 2 largos por si la distancia focal de tu microscopio fuera distinto. Existe además un margen interno que limita que el cristal del ocular pueda tocar la cámara y rallarse. -PLA (I use Creality CR-PLA black) -Recommended layer height 0.1mm (0.2mm also works). -Infill: 10-50%. -No support is needed -Print upside down (with the opening facing up) -Others: -4 (you can use just two if you like) M2 screws for fixing the camera to the adapter -2 M3 screws for fixing the adapter to the eyepiece (just if necessary)