Eyeglass Case - Magnetic Latch - Dual Extruder Mix

thingiverse

The original designer notes: "Any combination of the two files can be used to create a case; the sole difference is the design on the bottom.The file prints well without supports (I really wouldn't use supports on the patterned area). I did a color change at Z = 1mm to make the pattern stand out, printed with the patterned side flat on the bed.Looking better and hinges are stronger at a finer layer height. I did four perimeters for strength and plenty of top and bottom layers, so there really isn't any hatched infill on the part." "I truly enjoyed this design, but wanted an easier way to have it multi-colored. One color prints up to 0.8mm and rather than having to watch and switch filaments, the second extruder kicks in at that height."