Eye modification for InMoov

thingiverse

https://youtu.be/KJkI7B6X0zA https://youtu.be/wcRrQ2yKbFw This is a supplementary project to monnerby's Modified InMoov head, part 3 found on http://www.thingiverse.com/thing:1035688. Start by printing these parts. Next, print two Eye Horizontal Ball JointV1.stl and one of the other components of this Thing. The author printed the parts using PLA at a layer height of .2mm, with 2 shells and 50% infill. Servo holders are designed to fit EZ Robots Micro Servos, which can be found at http://www.ez-robot.com/Shop/AccessoriesDetails.aspx?prevCat=9&productNumber=13. Assemble the parts as shown in the photos. The servo levers should fit directly onto the servos using a press fit. Join the Eye Horizontal Servo Lever to the Eye Horizontal Tie Rod by screwing a small screw through the tie rod and into the lever, ensuring it slides freely in the slot of the tie rod. On October 2nd, 2015, The Eye Horizontal Tie Rod V1 was initially posted incorrectly. It has been corrected, and the correct part can be found here now. Additionally, on October 3rd, 2015, an Eye Horizontal Adj BallV1 has been added to enable adjustment of the eyes if necessary. Two tiny screws will be required for this process. Furthermore, a small tab was included in Eye Horizontal Adj BallV3 to make it easier to work with. However, once the eyes are adjusted correctly, it's recommended that you glue it into place. This modification complements Gael's original head design.