Eyas X3 Camera top plate & XT30 mount

thingiverse

This is a compact cam mount (Runcam micro sized) with built-in antenna holders that also serve as a protective casing for the camera, along with an XT30 mount doubling as a mounting surface for a LED strip and/or buzzer. Print this design in TPU/TPE/Ninjaflex. No supports should be needed, but you might have to insert a drill bit into the antenna tubes several times to open them up. Antennas can simply be pushed in or secured with a small amount of tape or glue after being inserted. The camera is intentionally positioned slightly high, leaving ample space below it for installing a HMDVR-S micro DVR (without its case) to record the camera signal onboard. It may also accommodate various micro VTX models. For the XT30 mount, apply some hotglue or similar over the exposed contacts. Super Glue can prevent the connector from coming loose. Use an M3 screw and nut, ideally with a washer, to secure the XT30 mount to the rear of the copter. This frame is extremely compact, but its size (112mm for 3-inch props) and weight make up for it, allowing easy assembly under 250g even on a 4S setup.