Extrusion corner brace

thingiverse

I downloaded this fantastic set of relocation brackets: https://www.thingiverse.com/thing:3991856 This is a straightforward remix that allows the original design to be used as corner braces elsewhere on the printer while maintaining uniformity, due to my perfectionism. Added: top and bottom braces in left- and right-hand versions. Edit for clarity of placement. The large brackets (corner brace) can fit into all four corners on the side faces of the printer, all four corners on the back face of the printer, and the rear two corners of the bottom face of the printer. The small brackets (top/bottom corner brace L and R) fit into the rear two corners of the top face of the printer and the front two corners of the bottom face of the printer. See additional photos. Further edit: I should point out why I created them in the first place. When I placed a precision engineer's square over the extrusions as provided, each cut was significantly off from 90 degrees. There was no way the frame would come together square, registering on the mis-cut ends. So I left all connecting bolts loose, installed these corner braces and pulled the frame square with them, then just snugly tightened the connecting bolts.