Extruding Toilet Humor Flat Cutout

thingiverse

Pretty straightforward modification of the original cutout version. If you're printing it as a cutout, you're likely using single-color mode, so the ridge isn't necessary. I bumped up the L and W to 170% and reduced the height to 0.8mm, making it sturdy enough to provide structural support while still hugging the surface closely. To top it off, I flipped it upside down, allowing the texture of my bed to become the visible surface. This resulted in a finish that's even smoother than ironing could achieve. I'll post an update with a finished picture once my print is complete - if I don't forget!