Extruder spacer and jig for CR-10 Direct Drive

thingiverse

Extruder Spacer for Direct Drive Mounts Extruder Stepper Above Heatbreak. Works with Various Setups Including TH3D. Feel Free to Modify for Your Own Use. This was created for a fellow user who needed a replacement spacer in his TH3D setup, but may fit other models as well. 11/19/2020: Added Simple Model with Larger Cutout to Fit Other Extruders with Official Creality Direct Drive for CR10, Ender 3, and Ender 5. Also added jig to reposition stepper. Creality direct drive converter bracket positions the stepper 15mm higher than it needs to be. Bolt the jig to the bracket using center holes on both sides, then drill out the bracket using bottom holes on each side (will need a 3.5-4mm drill bit for M3 bolts). Drill the center out (hole in the jig is 12mm wide, which should give adequate clearance for the stepper shaft).