Extruder PCB Mount

thingiverse

This is for the Monoprice IIIP+ extruder head assembly, designed to make the PCB on the head easier and lighter to handle. To assemble this mount, you'll need two 3M screws that are 10mm long, two 3M nuts measuring 5.5mm wide by 2.5mm tall (the standard size), and two small plastic washers used in the original mount, as well as two 4M screws at least 12mm long. The plastic washers were glued to the face of the board mounts for added stability. When assembling the printed part, you'll need to press fit the 3M nuts into place, or use a screw to pull them in instead of heating them up. The 4M holes may be a bit tight, so drilling them out might be necessary if you want them looser. Make sure to print with the large flat face down for optimal results.