Extruder Motor mount - relocation

thingiverse

I've always observed that my twin screw Z axis setup would occasionally get slightly out of sync, which bothered me greatly. The Creality design featuring both X-axis and Extruder motors on the left side was a major concern due to the substantial mass imbalance when compared to the right side's empty space. To resolve this issue, I came up with a straightforward bracket solution that relocates the Extruder motor from the left side to the right side, thereby better balancing the weight distribution on each lead screw. Following this modification, I've noticed significant improvement in the synchronization of the two sides, and the results have been consistently impressive from print to print.