Extruder filament cooler for geeetech Prusa I3X

thingiverse

Hey everyone,\nThis is my new extruder filament cooler for the Geeetech Prusa I3X printer. To install it, you'll need to rotate the extruder and position the heater block on the right side, leaving more space on the left for mounting. Mount the cooler using an M3 screw on the original carriage, then insert a 50mm radial FAN without any additional support.\nCheck out the attached picture...\nPrint Settings\nPrinter: \n Geeetech Prusa I3X\n \n Rafts: \n No rafts needed\n \n Supports: \n None required\n \n Resolution: \n 0.2mm resolution is recommended\n \n Infill: \n Use a 20% infill density\n \n Notes:\n For best results, use only ABS plastic.