Extruder Assembly ENDER-3 V3 SE

thingiverse

after making a couple of fan ducts my self never lined up with how i was making themfound the hot end just wasn't in correct spot so after few months of printed decided to strip down for a clean and measured up as much as i could be modified ctyler2621 design could still be some tweaks to be had but this took half a day and the last dual duct i made is working ok so will revisit that later on or till it melts like the last onealso attached my 5015 dual duct front/back which does need tweaking as duct outlets sit a few mm towards the front hence the rear duct may melt did end up tweaking touch sensor location at last minute so closer then it was also