Extrude mod V2 single 18650 "mechanical" diy vape mod

thingiverse

Here's an easy print box mod I've designed for use with a single 18650 battery, I've listed below all parts used to wire and connect it up to a fully functional "mechanical" mod. It functions like a mechanical in that power will go down as the battery dies, but when using the parts listed below, it has reverse polarity protection, low voltage protection and won't fire any higher than 50A. Similar to the cutouts for the 510 and the button are also for the parts below, but note the switch hole on right side is 12mm and the 510 is 10.5mm (space for an M10 thread). Switchfet V2.5 - https://modmaker.co.uk/Switchfet-V2.5 (MOSFET) Switch - https://modmaker.co.uk/12mm-Stainless-Steel-Clicky-Switch-With-Flat-Flush-Actuator?search=12mm Stainless Steel Clicky Switch With Flat Flush Actuator 510 connector - https://modmaker.co.uk/Fat-Daddy-Vapes-510-V3-Short-Body?search=Fat Daddy Vapes 510 V3 Short Body I used the contacts from one of these sleds - https://modmaker.co.uk/Blossom-1048-Dual-18650-Battery-Holder?search=Blossom 1048 Dual 18650 Battery Holder The wiring diagram for the MOSFET is included on the site linked. The drip tip included is made to fit this blank (not needed but looks pretty :) - https://modmaker.co.uk/510-Drip-Tip-Blanks-10mm?search=510 Drip Tip Blanks (10mm) NOTE: Dealing with electrics and batteries is dangerous. Please use utmost caution when building this, and triple check every connection made to make sure there are no issues. Any issues are at the user's discretion... you have been warned! Enjoy! :D When printing: Nothing needs support when printed in the orientation provided, but it is recommended as will give a better finish for the holes. I recommend rotating the box part 45 degrees so that it is stood upright and then printed with full supports. This will give the best overall finish when paired with the side cover.