Extrude Mod

myminifactory

Here's an easy print box mod I've designed for use with a single 18650 battery. Below are all parts used to wire and connect it up to a fully functional "mechanical" mod. It functions like a mechanical in power, going down as the battery dies, but when using the listed parts, it has reverse polarity protection, low voltage protection and won't fire higher than 50A. Similar to a mechanical mod, cutouts for the 510 and button are designed for the parts below, with note that the switch hole on the right side is 12mm and the 510 is 10.5mm (space for an M10 thread). The Switchfet V2.5, available at http://www.modmaker.co.uk/Switchfet-V2.5, is a MOSFET. The switch used is the 12mm Stainless Steel Clicky Switch With Flat Flush Actuator, also from http://www.modmaker.co.uk/12mm-Stainless-Steel-Clicky-Switch-With-Flat-Flush-Actuator?search=12mm%20Stainless%20Steel%20Clicky%20Switch%20With%20Flat%20Flush%20Actuator. The 510 connector is the Fat Daddy Vapes 510 V3 Short Body, available at http://www.modmaker.co.uk/Fat-Daddy-Vapes-510-V3-Short-Body?search=Fat%20Daddy%20Vapes%20510%20V3%20Short%20Body. I used contacts from one of these Blossom 1048 Dual 18650 Battery Holders, found at http://www.modmaker.co.uk/Blossom-1048-Dual-18650-Battery-Holder?search=Blossom%201048%20Dual%2018650%20Battery%20Holder. The wiring diagram for the MOSFET is included on the linked site. A 510 drip tip blank was used, which can be found at http://www.modmaker.co.uk/510-Drip-Tip-Blanks-10mm?search=510%20Drip%20Tip%20Blanks%20(10mm). Please note that dealing with electrics and batteries is dangerous. Use utmost caution when building this mod, and triple-check every connection to ensure there are no issues. Any issues are at the user's discretion; you have been warned! Enjoy!