"Extrude" Box mod dual 18650 DIY vape

thingiverse

Here's an easy print box mod I've designed for use in parallel and series. Room is available for different wiring configurations, but as shown in the pics, it's wired in parallel using the parts listed below. The cutouts for the 510 and button are also tailored to the components mentioned, although note that the switch hole on the right side measures 12mm, while the 510 measures 10.5mm, providing space for an M10 thread. The cover and box are precut for magnets as well, but I found they were unnecessary so never installed them. The magnets themselves can be obtained from the listed supplier below. Switchfet V2.5: http://www.modmaker.co.uk/Switchfet-V2.5 (MOSFET) Switch: http://www.modmaker.co.uk/12mm-Stainless-Steel-Clicky-Switch-With-Flat-Flush-Actuator?search=12mm%20Stainless%20Steel%20Clicky%20Switch%20With%20Flat%20Flush%20Actuator 510 connector: http://www.modmaker.co.uk/Fat-Daddy-Vapes-510-V3-Short-Body?search=Fat%20Daddy%20Vapes%20510%20V3%20Short%20Body Magnets: http://www.modmaker.co.uk/2mm-x-1mm-Rare-Earth-Neodymium-Magnets?search=2mm%20x%201mm%20Rare%20Earth%20Neodymium%20Magnets The contacts used were obtained from one of these sleds: http://www.modmaker.co.uk/Blossom-1048-Dual-18650-Battery-Holder?search=Blossom%201048%20Dual%2018650%20Battery%20Holder A wiring diagram for the MOSFET is included on the linked site, which I used due to its reverse polarity protection and low voltage protection features. The drip tip provided is designed to fit this blank (not needed but it looks pretty): http://www.modmaker.co.uk/510-Drip-Tip-Blanks-10mm?search=510%20Drip%20Tip%20Blanks%20(10mm) **Note:** Dealing with electrics and batteries can be hazardous. Please exercise extreme caution when building this, and triple-check every connection to ensure there are no issues. Any concerns are at the user's discretion; you have been warned!