Extremely Strong Samsung Soundbar Holder

prusaprinters

<p>Made to mount my 2016 Samsung Sound Bar behind my new TV, and ran some Fusion tests on it, and turns out it can support upwards of 15 pounds when mounted properly. I recommend using two for redundancy and to support it better, but you probably could get away with just one. Use 2" drywall screws or similar.</p><p>Recommended print settings</p><p>Print on its side, because that significantly reduces the time it takes to print, and also cuts down on cost.</p><p><strong>Infill:&nbsp;</strong></p><p>No less than 20%, Gyroid highly encouraged</p><p><strong>Rafts:</strong></p><p>None</p><p><strong>Brim:</strong></p><p>None</p><p><strong>Supports:&nbsp;</strong></p><p>Yes</p><p><strong>Material:</strong></p><p>Printed mine in PETG, but if you were gonna use these for something heavier, use ASA or PC</p><p><strong>Perimeters:</strong></p><p>I went with 4 on mine, however this is up to you (I recommend 3+)</p><p><strong>Print Time:</strong></p><p>About 5 hours a piece, uses $2.45 worth of (PETG) filament</p><p>Full Disclosure, I took the picture as soon as I finished the print, so I didn't have the Sound Bar installed on it yet. Please don't sell these:)</p>