Extra Thin BIQU H2 Mount (MAD Compatible) - Ender 3

thingiverse

Extra Thin H2 Mount ========= This model is designed specifically to work with Predy's [“MAD - Modular Air Duct for BIQU H2”](https://www.printables.com/model/146957-mad-modular-air-duct-for-biqu-h2) ------------------ Reclaim lost build volume on your ender 3 with **the thinnest mount out there!** This mount is only **5mm thick** while still being rigid enough to handle relatively fast accelerations without too much wobble. The removeable fan mount makes the already hard to service H2 just a little bit easier and allows you to have two colours to *match your aesthetic.* **(There are a few ender 3 backplate variations, check first)** Print Settings ==================== **The file "H2 MountPlate" makes use of sacrificial bridges to avoid support!** * 0.15mm Layer Height *(A must for the sacrificial bridges to work!)* * No Support * 100% infill for rigidity * I used PLA as it is quite rigid, however, ASA or nylon may be better choices. Hardware ==================== * 4x 6-8mm M3 Button Head Screws (6 and 8mm both work fine) * 2x 20mm M3 Button Head Screws