External Hard Drive Stand for Seagate 3.5 Inch Hard Drives and Similar

thingiverse

<h1>External Hard Drive Stand</h1> These little feet are meant to hold your 3.5" external hard drive upright in a vertical position. A straightforward design is used here. To make the drive stand up properly, you need at least two of these stands. They measure 37mm wide and were designed specifically for a Seagate expansion hard drive. I assume they will also work with other 3.5 inch external drives but may require scaling in your slicer to fit perfectly. I used small sticky rubber feet on the bottom of my stands, which greatly helped prevent the drive from sliding around. <h1>Links to My Other Designs</h1> Thanks for checking out my design! If you need a [webcam mount](https://www.thingiverse.com/thing:3868835) or a [raspberry pi touchscreen case](https://www.thingiverse.com/thing:3819365) for an ender 3, ender 3 pro, or teva tornado, be sure to look at my other creations!