External Hard Drive Dock (Western Digital)

thingiverse

This is my inaugural upload and full transparency, I haven't yet printed this. I created all three parts in one file and then separated them so at least theoretically, they will fit together seamlessly. Initially, I designed this to accommodate 3 HDDs but I envision it's only a matter of time before I acquire a fourth so I've developed a more modular design that will allow for additional units to be added without requiring a whole new dock. Extremely simple design should print upright but Will probably require at least minimal infill. Although I haven't printed this, I've measured and confirmed the cables will fit and the drive itself will fit neatly, though I included a slight extra allowance on the sides in case of any warping during printing (only 1mm on the sides). Hopefully, when I obtain some filament (I just acquired my printer), I'll be able to post a photo of the completed product. UPDATE: Inside new models added with a flat base after it was pointed out that the angle may not be suitable for the spinning drive. I believe given that it still spins on the same axis, it should be acceptable but I'm certainly no expert. New versions were added anyway.