Extension for No Hardware - IKEA Lack Side Table Extender/Stacker

thingiverse

I wanted to stack a small Lack 55x55 on top of a bigger lack 55x90, so I created some custom stacking elements for the sides. I printed the parts from this design without any support material, but I recommend printing with support if you're unsure about your printer's ability to handle bridging. After slicing the side stacking part, it formed a ring connector (as seen in the screenshot) - not sure why this happened, but it still works just fine. You'll need every part duplicated except for the inner connector. Additionally, you'll require two of Cyberlamb's Corner pieces. If you consider leaving a tip, don't forget to support Cyberlamb.