"Extended Tip" mod of Tronxy e3d Modular Hurricane 5015 and BLTouch wings

thingiverse

I've tried several e3d mounts for the Tronxy x5s and the CR10/Tronxy e3d Modular Hurricane mount is a top-notch option - but it can cause significant issues for those new to 3D printing. When using the wings with higher-flowing 5015 fans, too much air can blow onto the hotend heatblock, causing temperatures to drop by 10-20c when the fans switch on at layer 2. On a Tronxy x5s, this results in an inability to heat back up to the target temperature within the default time limits set in Marlin 1.1.8 firmware, leading to "thermal runaway" type errors. I used Tinkercad to extend the tips of the "5015" and 5015_BLTouch" wings of the CR10/Tronxy e3d Modular Hurricane mount to better direct airflow towards the tip of the hotend and away from the hotend heatblock. As a non-expert in 3D design or Tinkercad, I needed a solution and this is the best outcome I could achieve - it does exactly what it needs to do. If you'd like to improve upon this design, the Tinkercad link is: https://www.tinkercad.com/things/ghS1KSAZdsm-cr-10-x5s-hurricane-modular-mount-v6-extended-tip-wings/editv2?sharecode=ixfSAOJz_96wsE_X7BEFI0b6OrxkcxF9uhlrminX48Q