Extended Golf Handle - Quest 2

thingiverse

For putting / golf games on Quest2 Because this uses the original controller orientation it seems to work fine without needing pre calibration for specific grip models, which is as of today is not supported in the games I use. Gripping lower on handle may have unintended results in some games, otherwise if keeping the main hand near original controller grip position this should work per normal, but with the benefit of having somewhere to grip for your second hand. Be sure to use the wrist strap looped through the hole and attached to your wrist per usual when playing for a more secure setup. The clip alone (even the tighter T2 version) is insufficient IMO but looping a ponytail band or otherwise through that area (or through the wrist strap again) to the controller halo is an additional connection point if desired (see photo under “makes”). The t2 tightening clip should slightly tighten when pushed; may need to be tapped against a hard surface in opposite direction to remove, but I just leave it on as controller can still slide in/out with some force. If holding the controller with primary hand touching main black button pad there’s not much risk of falling out, these precautions (clip+ ponytail band+ wrist strap) are mostly for taking larger swings lower in the grip (at your own risk, but no issues on my end so far)…but mostly this setup is for the second hand placement per notes at the top. I’m not a pro designer, works for me, and posting as is, just was tired of waiting for something like this to be posted so finally decided to give it a try, have invested several hours so far (mostly on minor tweaks that take a while for my experience level) but i'm sure there are ways to improve, lmk in comments or makes if any feedback (or feel free to remix again and post as v2 etc.) My profile is linked to paypal for tips but they are not at all expected or required; happy to keep this as a free non-commercial design for as many to enjoy as possible. Uploaded with multiple files options (pick any handle and clip combined or printed separately) - benefit of printing separate is if you want to print the handle portion upside down for increased stability (with supports recommended for inside) or if wanting to try the original vs tighter clip (tighter clip is harder to remove in exchange for some additional security) +This is for the right hand/controller but mirroring in cura should be able to create the L hand equivalent if ever needed? +See printing notes below