Extended French Door Stay

thingiverse

After a few months the original French Door Stay I printed ended up snapping... I think this is because I didn't make it strong enough (i.e. not enough infill) but also because of a couple of design limitations : Teeth too far apart - allows too much movement in wind, allowing stay to fall off Too short a gap - enthusiastic dogs rushing to get out forced the door open I used Tinkercad to cut & paste the bits around, which may have resulted in some slight imperfections when printing, hadn't noticed them when designing (sorry!) However the Teeth are now closer together, hopefully reducing the chances of the wind movement resulting in the unit dropping off. And there are two lengths included, 27cm and 30cm, depending on your dog (and printer bed!) size... Have printed the 27cm one myself at 50% infill, hoping this lasts a little longer... :D